Connect Reverse ETL Source to Klaviyo Bulk Upload

Configure a Reverse ETL source with your Klaviyo Bulk Upload destination.

  •   less than a minute  

This guide takes you through the steps to connect a Reverse ETL source to the Klaviyo Bulk Upload destination.

Set up connection

warning

The Reverse ETL feature supports only source-driven pipeline configuration.

Make sure you have set up a RETL source and connected it to your Klaviyo Bulk Upload destination before following the below steps.

  1. Confirm the connection settings for Klaviyo Bulk Upload destination and click Continue.

  2. In the Data Mapping section, select the Object as User Profiles .

  3. Specify the Sync mode. RudderStack supports syncing to this destination only via the Upsert mode.

  4. In Choose identifier, specify the warehouse column that RudderStack uses to identify your records.

info
You can map this warehouse column either to the User ID, ID, or Email Klaviyo fields.
  1. Map the other warehouse columns to specific Klaviyo Bulk Upload fields using the Map fields setting.

FAQ

Why can’t I add a Reverse ETL source from the destination page?

The Reverse ETL feature supports only source-driven pipeline configuration. It means that you must configure a Reverse ETL source in RudderStack and then connect it to a new or existing destination. Note that this destination should not be connected to any other source.

See Reverse ETL FAQ for more information.


Questions? Contact us by email or on Slack