Setup Guide

Set up and configure Bloomreach Catalog as a destination in RudderStack.

  •   less than a minute  

This guide will help you set up Bloomreach Catalog as a destination in the RudderStack dashboard. It also lists the configuration settings required to correctly send data from the supported sources to Bloomreach Catalog.

Setup

  1. In your RudderStack dashboard, set up a Reverse ETL source.
  2. In the Overview tab of the source, click Add Destination > Create New Destination.
  1. From the list of destinations, select Bloomreach Catalog and click Continue.

Connection settings

SettingDescription
NameAssign a name to uniquely identify the destination.
API Base URLEnter your Bloomreach instance URL found under Project settings > Access management > API in your Bloomreach dashboard.
API KeyEnter the Bloomreach API key.
API SecretEnter the Bloomreach API secret.
Project TokenEnter the project token for your project under the Bloomreach instance. You can find it under the Project settings > Access management > API in your Bloomreach dashboard.
Catalog IDEnter the Bloomreach catalog ID that RudderStack uses for syncing your catalog data.

Next steps

FAQ

Where can I find the Bloomreach catalog ID?

  1. Log in to your Bloomreach dashboard.
  2. Go to Data & Assets > Catalogs and select your catalog.
  3. Note the catalog ID present in the resulting browser URL, as shown:

Questions? Contact us by email or on Slack